Logo

B3852 Engine Trouble Code

Meaning of B3852 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B3852 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for B3852 code is occuring now you should check B3852 repair processes.
Now don't ask yourself; What should you do with B3852 code ?
The solution is here :

B3852 Possible Solution:

B3852 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B3852 Code Meaning :

B 3 8 5 2
OBD-II Diagnostic Body (B) Trouble Code For Engine Ignition System Or Misfire Engine Oil Temperature Sensor Malfunction Cylinder 1 Injector Circuit Low Glow Plug/Heater Circuit 'A' Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B3852 OBD-II Diagnostic Body (B) Trouble Code Description

B3852 engine trouble code is about Glow Plug/Heater Circuit 'A' Malfunction.

Main reason For B3852 Code

The reason of B3852 OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

B3852 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.